Matthews 5/8″ Pin with 1/2″-13 MSE Telescoping Hangers

Introduction

Matthews Telescoping Hangershave a very substantial pipe clamp to attach to a lighting grid. The pipe clamp has been slightly offset to allow the riser or drop down tube to slide up when there is sufficient room between the grid and the ceiling. It is therefore possible for a 3′ Single Extension Hanger to be able to go from a few inches below the grid to the fully extended 3 feet.Matthews Telescoping Hangers are available in single stage and double stage.

Matthews Hangers are engineered with an internal mechanical stop which will prohibit the Riser from falling through should the lock off knob be inadvertently released.

All hanger pipes terminate in female 1/2″-13 thread. ThisMatthews 5/8″ Pin with 1/2″-13 Thread for MSE Telescoping Hangershas male 1/2″-13 threads to work into the female threads and a 5/8″ pin to which the gear is attached.

Features:

• Mounts Gear to Telescopic Hangers