TetherTools Relay Camera Coupler for Nikon Cameras with EN-EL9a Battery

Introduction

Relay Camera Couplerswork in tandem with the Case Relay Camera Power System to keep your camera powered continually with an external 5V USB battery pack or wall power. The Relay Coupler is simply an insert for your camera battery cavity that enables powering the camera via Case Relay Camera Power System. The coupler does not contain a battery or hold a charge.

Simply insert the Relay Camera Coupler directly into the camera battery port, attach it to the Case Relay CPS and power your camera with the included Rock Solid External Battery Pack or an AC power source using an USB to AC wall adapter or use the ONsite D-Tap Battery with V-Mount. Because Case Relay also has its own secondary internal 1200 mAh battery, if your external battery runs low you can easily hot swap the external battery and not lose power to the camera.

Features:

• Connects camera to ONsite Relay System
• Coupler cable is 10 (25.4cm) Coupler cable with Relay cable is 50 (127cm)
• More cost effective than purchasing multiple proprietary camera batteries
• Power sources are non-proprietary. Power your camera with the same 5V battery you use to charge phones or tablets.
• Never need to charge camera batteries again. And never run out power.
• A Case Relay Camera Power System (sold separately) is required to use the Relay Camera Coupler.

In The Box:
TetherTools Relay Camera Coupler for Nikon Cameras with EN-EL9a Battery

*Note:The coupler does not contain a battery or hold a charge.A Case Relay Camera Power System (sold separately) is required to use the Relay Camera Coupler.