Epson Roll Paper Unit P906

Introduction

Epson Roll Paper Unit P906

This Epson Roll Paper Unit enables the use of roll-based media in widths from 13into 17insupplied on either a 2inor 3incore. It attaches to the rear of the printer and supports a range of media types with prints made borderless or with borders.

Important Notes:
Prints up to a maximum length of 3.3m can be made however accurate sizing cannot be guaranteed for prints over 1.1m. A minimum of 50mm will be lost at the start of each print job and a further 14mm at the end of each print job due to media feed requirements. If multiple images are sent to print as a single job border between the images can be reduced to as small as 0mm.
The printer does not include an auto-cutter so manual cutting is required. When printing on matte media resolution is restricted to a maximum of 1440x720dpi.
Media with a weight of LESS THAN 250gsm may only be used if mounted on a 2incore. If such media is used on a 3incore it can damage the printer and invalidate the warranty.